Sharp MX-2300N System Settings Manual page 121

Disabling of Tray Setting
This setting is used to prohibit tray settings.
To enable this setting, select the checkbox
touch the [OK] key.
Disabling of Finisher
(When a saddle stitch finisher or finisher is
installed.)
This setting is disable the saddle stitch finisher or
finisher, such as when the unit malfunctions.
To enable this setting, select the checkbox
touch the [OK] key.
Disabling of Offset
This setting is used to disable the offset function.
To enable this setting, select the checkbox
touch the [OK] key.
Disabling of Stapler
(When a saddle stitch finisher or finisher is
installed.)
This setting is used to prohibit stapling, such as when
the stapler unit of the finisher or the saddle stitch
finisher malfunctions.
To enable this setting, select the checkbox
touch the [OK] key.
Disabling of Punch
(When a punch module is installed.)
This setting is used to prohibit punching, such as
when the punch module of the finisher or the saddle
stitch finisher malfunctions.
To enable this setting, select the checkbox
touch the [OK] key.
Disabling of Colour Mode
(When a colour-related problem has occurred.)
When a colour-related problem has occurred and
printing is not possible, the use of colour mode can be
prohibited on an emergency basis and only black and
white printing allowed.
To enable this setting, select the checkbox
touch the [OK] key.
This function is only for use as an emergency
measure. Once this setting is enabled, only a service
technician can cancel the setting. Promptly contact
your dealer or nearest authorised service
representative to have a service technician cancel the
setting and resolve the colour-related problem.
Disabling of Master Machine Mode
This prohibits the use of the machine as a master
and machine for tandem printing.
To enable this setting, select the checkbox
touch the [OK] key. (Normally this setting is not
necessary.)
Disabling of Slave Machine Mode
This prohibits the use of the machine as a slave
machine for tandem printing.
and To enable this setting, select the checkbox
touch the [OK] key. (Normally this setting is not
necessary.)
and
Copy Settings
Disable Copy in Different Size/Direction
This is used to prohibit copying when the paper and
original are placed in different orientations or the
proper size of paper is not loaded.
To enable this setting, select the checkbox
touch the [OK] key.
and
This setting is only effective when
Setting" (page 97) is disabled.
Disabling Deletion of Job Programs
This is used to prohibit the deletion and changing of
copy settings stored in job programs.
To enable this setting, select the checkbox
and
touch the [OK] key.
Disabling of Bypass-Tray in Duplex Copy
This is used to prohibit the use of the bypass tray
when making two-sided copies.
The bypass tray is often used to feed label sheets,
transparency film, and other special papers for which
two-sided copying is prohibited. If one of these
special papers enters the reversing unit, a misfeed or
and
damage to the unit may result. If special papers for
which two-sided copying is prohibited are often used,
it is recommended that you enable this setting.
To enable this setting, select the checkbox
touch the [OK] key.
120
and
and
and
"Rotation Copy
and
and