Operation Settings - Sharp MX-2300N System Settings Manual

Operation Settings

Settings related to machine operation can be configured. Touch the [Operation Settings] key and configure the settings.
Keys Touch Sound
This setting is used to adjust (or turn off) the volume of
the beep that sounds when you touch a key. You can
also have three beeps sound at initial values when
setting the ratio in copy mode or when adjusting the
exposure in any mode.
System Settings
Keys Touch Sound
Keys Touch Sound
Key Touch Sound at Initial Point
Volume: Volume:
Small Middle
Select one of the keys and touch the [OK] key.
When "Key Touch Sound at Initial Point" is selected
three beeps will sound at the initial values indicated
below.
Screen in which setting is
effective
Ratio setting screen in base screen
of copy mode
Exposure adjustment screen in
base screen of copy mode
Exposure adjustment screen in
base screen of fax, Internet fax,
and network scanner modes
Exposure adjustment screen in
[Scan to HDD] in base screen of
document filing mode
OK
Volume: No Sound
Big
,
Initial value
Ratio 100%
Exposure level 3
(middle level)
Auto Clear Setting
The time until Auto Clear activates can be set to any
number of minutes from 10 to 240.
Make sure the [Cancel Timer] checkbox is not selected
, specify the time with the
the [OK] key. (To make the number change quickly,
keep your finger on the
If the machine is not used for the duration of time set
here, the auto clear function will clear any settings that
have been selected and return the screen to the base
screen of copy mode or the job status screen.
If you do not want Auto Clear to operate, select the
[Cancel Timer] checkbox
Message Time Setting
The duration of time that messages appear in the display
(the time until a message is automatically cleared) can
be set to any number of seconds from 1 to 12.
Specify the time with the
[OK] key. (To make the number change quickly, keep
your finger on the
Display Language Setting
The language that appears in the display can be
changed.
Select one of the keys and touch the [OK] key.
When user authentication is enabled, the display
language setting is given priority when it is configured
in the favourite operation group.
Disabling of Job Priority Operation
The job priority function can be disabled. When this is
done, the [Priority] key will not appear in the job status
screen.
To enable this setting, select the checkbox
touch the [OK] key.
91
keys, and touch
or key.)
.
keys and touch the
or key.)
and