Figure 3.28: Static Trunking Group Of 2 Ports On Single Switch; Figure 3.29: Aggregator Information - Advantech EKI-7657C User Manual

Figure 3.28: Static trunking group of 2 ports on single switch

When you have set up the aggregator setting of two interconnected switches with LACP enabled, you will
see the respective LACP trunk group information as below. 'Actor' means the switch which is connecting
to the host computer.
State Activity
Having set up the LACP aggregator on the tab of Aggregator Setting, you can configure the state activity
for the members of the LACP trunk group. You can tick or cancel the checkbox beside the state display.
When you remove the tick mark to the port and click Apply , the port state activity will change to
Passive.
• Active: The port automatically sends LACP protocol packets.
• Passive: The port does not automatically send LACP protocol packets, and responds only if it receives
LACP protocol packets from the opposite device.
Note A link having either two active LACP nodes or one active node can perform
dynamic LACP trunk.
A link having two passive LACP nodes will not perform dynamic LACP trunk

Figure 3.29: Aggregator Information

61 Chapter3