Port Mirroring Commands Set; Table 3.12: Port Mirroring Commands Set; Commands Set; Table 3.13: 802.1X Commands Set - Advantech EKI-7657C User Manual

sub-oid
[OID]
show snmp
no snmp community-strings
[Community]
no snmp-server host
[Host-address]
no snmpv3 user
[User Name]
no snmpv3 access context-name
[Context Name ]
group
[Group Name ]
security-level
[NoAuthNoPriv|AuthNoPriv|AuthPriv]
match-rule
[Exact|Prifix]
views
[Read View Name] [Write View Name]
[Notify View Name]
no snmpv3 mibview view
[View Name]
type
[Excluded|Included]
sub-oid
[OID]
3.1.12

Port Mirroring Commands Set

Table 3.12: Port Mirroring Commands Set

Netstar Commands
monitor rx
monitor tx
show monitor
monitor
[RX|TX|Both]
show monitor
no monitor
3.1.13 802.1x Commands Set

Table 3.13: 802.1x Commands Set

Netstar Commands
8021x enable
8021x system radiusip
[IP address]
8021x system serverport
[port ID]
Show SNMP configuration
P
Remove the specified community.
G
Remove the SNMP server host.
G
Remove specified user of SNMPv3
G
agent.
Remove specified access table of
SNMPv3 agent.
G
Remove specified mibview table of
SNMPV3 agent.
G
Level Description
Set RX destination port of monitor
G
function
Set TX destination port of monitor
function
G
Show port monitor information
P
Configure source port of monitor
I
function
Show port monitor information
I
Disable source port of monitor
I function
Level Description
Use the 802.1x global
G
configuration command to enable
802.1x protocols.
Use the 802.1x system radius IP
global configuration command to
G
change the radius server IP.
Use the 802.1x system server port
G
global configuration command to
35
switch#show snmp
switch(config)#no snmp community-strings public
switch(config)#no snmp-server host 192.168.1.50
switch(config)#no snmpv3 user Test
switch(config)#no snmpv3 access context-name
Test group G1 security-level AuthPr
iv match-rule Exact views V1 V1 V1
switch(config)#no snmpv3 mibview view V1 type
Excluded sub-oid 1.3.6.1
Example
switch(config)#monitor rx
switch(config)#monitor tx
switch#show monitor
switch(config)#interface fastEthernet 2
switch(config-if)#monitor RX
switch(config)#interface fastEthernet 2
switch(config-if)#show monitor
switch(config)#interface fastEthernet 2
switch(config-if)#no monitor
Example
switch(config)# 8021x enable
switch(config)# 8021x system radiusip 192.168.1.1
switch(config)# 8021x system serverport 1812
Chapter3