Subset Finishing - Xerox 6100BD - Phaser Color Laser Printer System Manual

Subset finishing

System Guide
4 Finishing
The following section contains information about how to use
subset finishing and mixed stacking on a printing job.
The finishing information below does not apply to Continuous
Feed (CF) systems. For CF systems, the finishing configuration is
defined at the CF (STAMPA) Controller. CF imposition files are
used to impose documents for printing in conjunction with specific
CF finishing configurations.
Subset finishing is the capability to use different types of finishing
(or no finishing) within the same job. The ability to finish subsets
independently is a critical feature for many variable data
applications
This product allows more than one type of finishing within a single
PostScript job. The supported finishing options and the output
locations that can be used vary depending upon the printer type.
The finishing options and delivery locations are the following:
• Portrait Stitch
• Landscape Stitch
• Dual Stitch
• Right Portrait Stitch
• Right Landscape Stitch
• Right Dual Stitch
• Bind
• Right Bind
NOTE: The DT 61xx printers allow Short Edge Feed (SEF) only in
paper tray 3, 4, and 5. The short edges of the stocks range from
approximately 10 inches to 14 inches (254mm to 300mm).
Finishing
4- 1