Font Problems; Inoperable System Problems - Xerox 6100BD - Phaser Color Laser Printer System Manual
Freeflow® print server system guide
Hide thumbs
Also See for 6100BD - Phaser Color Laser Printer:
- Software manual (506 pages) ,
- Fundamentals (172 pages) ,
- Manual (168 pages)
Table of Contents
Advertisement
System Guide
1. Retrieve the error page if one was printed.
2. Submit the job to a draft PostScript printer if one is available to
determine if the master is valid.
3. Ensure that jobs are sent to the correct queue.
4. Ensure that a valid PDL is used.
5. If the problem still exists, recreate the job with a different print
driver and resubmit the job to the printer.
Font problems
A font problem exists when incorrect printed fonts have character
spacing, jagged characters, text running off the page, or
sentences running into each other.
To determine and fix the font problem, perform the following:
1. Determine if the font is being downloaded with the job.
NOTE: If a downloaded font is not found, font substitution
occurs and an error page is printed.
2. If the font is not being downloaded with the job, determine if
the font is loaded on the server by viewing the Fonts module of
the Xerox FreeFlow Print Server.
3. If jagged characters are seen, determine if there is a scalable
option available for that font and whether the user selected
that option.
4. For incorrect characters or text that runs off the page,
determine if the document was created with one driver and
printed with another driver.
5. If you are comparing prints from a proof printer, ensure that the
same PDL file was used to make the prints on both printers.
6. If small fonts are printing ragged, change the default font
renderer in Print Manager from the "Adobe Type Manager" to
the "Font Solution".
Inoperable system problems
Determine which partition is full by opening a terminal window and
perform the following:
1. Telnet using another system into the controller and use the su
command to become the root user.
2. At the # prompt, type:sync; sync; halt and press <Enter>.
3. At the ok prompt, type boot
NOTE: Pressing <Stop> and <A> may result in lost information if a
job is currently being received by the system. Jobs would need to
be resent.
Troubleshooting
8- 7
Advertisement
Table of Contents
Troubleshooting
