Figure 3.11: Snmp Traps Window - IBM 1735-2GX Installation And User Manual

44 GCM2 and GCM4 Installation and User's Guide

Figure 3.11: SNMP Traps Window

To configure SNMP traps, complete the following steps:
1. Log into the Web interface as a user with Appliance Administrator rights.
2. Click the Configure tab and then click SNMP > Traps in the left menu.
3. Select or clear the Enabled Traps check box to enable or disable traps.
4. If SNMP traps are enabled, select the check box to enable each SNMP trap.
5. Click Save.