Figure 3.18: Co Version Window - IBM 1735-2GX Installation And User Manual

50 GCM2 and GCM4 Installation and User's Guide

Figure 3.18: CO Version window

4. Click the X in the upper right of the window to return to the CO Versions window.
To configure automatic or individual CO cable firmware upgrades, complete the following
steps:
1. Log into the Web interface as a user with Appliance Administrator rights.
2. Click the Configure tab, and then click Versions > CO in the left menu.
3. To enable automatic upgrades of subsequently connected CO cables, complete the following
steps.
a. Click the Enable Auto-Upgrade for all COs button. A confirmation window appears.
b. Click OK to continue.
4. To load and upgrade CO cable firmware, complete the following steps:
a. Click the eID of the CO cable. The CO Version window opens.
b. Compare the Application version to the Firmware Available Application version show.
(You can load firmware even if the current and available versions are the same. In some
cases, you can downgrade the CO cable to an older, compatible version.)
c. Click the Load Firmware button. The firmware upgrade begins. During the upgrade, a
progress message is displayed below the Firmware Available box and the Load
Firmware button dims. When the upgrade is finished, a message appears indicating that
the upgrade was successful.
d. Click the X in the upper right of the CO Version window to return to the CO Versions
window.
e. Repeat steps a-d for each individual CO cable to upgrade.