Table of Contents
Advertisement
To configure sessions, complete the following steps:
1.
Log into the Web interface as a user with Appliance Administrator rights.
2.
Click Configure > Appliance > Sessions.
Figure 3.4: Appliance Sessions window
3.
Configure Video Session parameters by performing the following steps.
a.
Select the Session Timeout check box and enter a number of minutes to elapse before
inactive video sessions are closed.
b.
Select the Video session preemption timeout check box and type a number of seconds
between 5 and 120. This sets a delay between when a preemption warning message is sent
and when the video session is preempted. If the preemption timeout option is not enabled,
preemption occurs without warning.
NOTE: Changes made to video session parameters affect only future sessions.
4.
Configure encryption (128, DES, 3DES, AES) by performing the following steps in the
Encryption area of the window. Video encryption is optional but at least one Keyboard/Mouse
encryption level must be set.
a.
Select none, one, or more Video encryption check boxes.
b.
Select one or more Keyboard/Mouse encryption check boxes.
5.
To configure KVM session sharing, select the Enable Share mode check box and complete
the following steps.
a.
To enable secondary users to share KVM sessions without requesting permission from
primary users, select the Automatic check box.
b.
To enable primary users to prevent sharing of sessions, select the Exclusive check box.
Chapter 3: Using the Web Interface
35
Hide quick links:
Advertisement
Table of Contents
