Restoring The Factory Set Values - A&D SW-150KL Instruction Manual

11.3. Restoring the factory set values

If the gravity acceleration value or calibration weight value is changed unintentionally,
restore those values to the factory setting values, as follows.
Make sure that the scale is in the weighing
mode (displaying "kg" ("g"), "lb", "oz" or "pcs").
1. Press and hold the
the gravity acceleration value appears, and
release the switch.
2. Press the
ClrC
display "
.
3. Press the
ClrC no
" " with "
4. Press the PRINT switch.
ClrC no
" " changes to "
go
" " blinking.
ClrC go
5. When "
TARE switch. The factory setting values
are restored and "
To finish the restoring procedure, turn the
power OFF.
To cancel the restoring procedure, press the
ZERO switch. The display returns to step 2.
TARE switch until
UNITS switch twice to
" .
TARE switch to display
no
" blinking.
ClrC go
" is displayed, press the
end
" is displayed.
Press and hold
(more than 4 seconds)
Release
" with
21
Press twice
Press
Press
Press