Entering The Comparator Values - A&D SW-150KL Instruction Manual

10.2. Entering the comparator values

1. In the weighing mode, press and hold the SAMPLE switch to enter the comparator
value setting mode.
2. Enter the comparator values using the following switches.
UNITS
PRINT
SAMPLE
TARE
3. When the setting is complete, "
weighing mode.
Five-level comparator mode
Press
and hold
Press
Press
Press
Press
To shift the blinking digit to the right.
To increase the value of the blinking digit by one.
To switch the polarity.
Each time the switch is pressed, "-" is turned on and off at the left-
most digit. When on, the value is negative.
To confirm and store the setting value.
end
Weighing mode
To set the LOLO
limit value
To set the LO
limit value
To set the HI
limit value
To set the HIHI
limit value
Weighing mode
" is displayed and the scale returns to the
Three-level comparator mode
Press
and hold
Press
Press
18
Weighing mode
To set the LO
limit value
To set the HI
limit value
Weighing mode