A&D SW-150KL Instruction Manual page 32

Data example
Weighing data "kg" (+)
Weighing data "g" (-)
Counting data "pcs" (+)
Out of weighing range (+)
Data output mode (
Command mode
The scale is controlled by commands that come from an external device such as a
personal computer. For details, refer to "13.2.3. Command mode".
Stream mode (
Data is sent continuously. The data update rate is approximately 10 times per
second, the same as the display refresh rate.
There will be no output during the setting procedures.
Print switch mode (
When the weight display is stable, data is sent by pressing the PRINT switch.
At this time, the display flashes once to indicate that the data is sent.
Auto-print mode +/- data (
When the weight display is stable at ±5d (d = minimum display in kg) and above
+5d or below -5d, the data is sent. The next transmission can not occur until after
the weight display falls between –4d and +4d.
Auto-print mode + data (
When the weight display is stable at +5d (d = minimum display in kg) and above,
the data is sent. The next transmission can not occur until after the weight display
falls +4d or below.
bp5
Baud Rate ( )
Select the baud rate according to the device to be connected.
bp5 0
2400 bps (
bp5 1
4800 bps (
bp5 2
9600 bps (
S T
S T
Q T
O L
prt
)
prt 0
)
prt 2
)
prt 3
prt 4
)
) Select 2400 bps to connect to an AD-8121 printer.
)
)
, + 0 0 1 2
, - 0 0 0 0 1 2 3 4 _ _ g
, + 0 0 0 1 2 3 4 5 _ P C
, + 9 9 9 9
)
30
. 3 4 5 _ k g
. 9 9 9 _ k g
C L
R F
C L
R F
C L
R F
C L
R F