10.4. Restoring the calibration data to the factory set values
If the gravity acceleration value or calibration data is changed unintentionally, restore
those values to the factory set values, as follows.
1. Refer to "10.1. Calibration mode" to enter the
calibration mode. The gravity acceleration value is
displayed.
2. Tap the
UNITS
3. Tap the
TARE
no
"
" blinking.
4. Tap the
SAMPLE
ClrC no
"
" changes to "
blinking.
To cancel the restoring procedure, tap the
switch. The display returns to step 2.
ClrC go
5. When "
switch. The factory set values are restored
TARE
end
and "
" is displayed.
Then, the display returns to "
To finish the setting procedure, touch the
switch or press the
the power OFF.
switch twice to display "
switch to display "
switch.
ClrC go
" with "
" is displayed, tap the
ClrC
"
switch. The scale turns
CAL
ClrC
".
ClrC no
" with
go
"
19
Tap twice
Tap
Tap
Tap