Restoring The Factory Set Values - A&D SW Series Instruction Manual

12.4. Restoring the factory set values

If the gravity acceleration value or calibration weight value is changed unintentionally,
restore those values to the factory set values, as follows.
1. Refer to "12.1. Calibration mode" to enter
the calibration
acceleration value is displayed.
2. Press the
ClrC
" " .
.
3. Press the TARE key to display "
no no
" with "
4. Press the PRINT key.
ClrC no
" " changes to "
go
" " blinking.
 To cancel the restoring procedure, press the
ZERO key. The display returns to step 2.
ClrC go
5. When "
TARE key. The factory set values are
restored and "
To finish the setting procedure, press the
ZERO1 key or the CAL switch. The scale
returns to the weighing mode.
mode. The
UNITS key twice to display
" blinking.
ClrC go
" is displayed, press the
end
" is displayed.
gravity
ClrC
" with
26
Press twice
Press
Press
Press