Boot Device Priority; Dimm Slot Led Blink Codes - HP D7171A - NetServer - LPr Reference Manual

Boot Device Priority

The boot device priority is controlled by the Boot Device Ordering submenu of the Configuration menu of the Setup
utility.
IDE CD-ROM drive with bootable CD-ROM
Flexible Disk with bootable flexible disk
Embedded SCSI controller
PCI boards in slots in the following order: 6, 5, 4, 3, 2, 1.
Hard Drive Priority: Allows you to rearrange the order in which hard disk drives are searched for the operating
system. All hard disk drives in the system are listed, as well as any bootable ISA board.

DIMM Slot LED Blink Codes

Processor Error Codes
Processor errors are indicated by blinking patterns of the DIMM slot LEDs that alternate at 1 Hz, as listed below:
²
= LED off
O = LED on
LED LED LED LED
0 1 2 3
4
Backplane:
System Board
LED 0
LED 1
LED 2
LED 3
Processor Error Status Indications
Error Condition
System
Board
Slot
PCI 6 - 32-bit
PCI 5 - 32-bit
PCI 4 - 32-bit
PCI 3 - 32-bit
PCI 2 - 32-bit
PCI 1 / ISA -
16-bit ISA or
32-bit PCI
Action