Installing A Floppy Drive - Dell GX280DT - GX280 Desktop Computer User Manual

1 power cable
2 floppy-drive cable
3 floppy-drive connector (DSKT)
4. Press inward on the two tabs on the sides of the drive, slide the drive upward, and remove it from the floppy-drive bay.

Installing a Floppy Drive

1. If the replacement drive does not have the bracket rails attached, remove the rails from the old drive by removing the two screws that secure each rail
to the drive. Attach the bracket rails to the new drive by aligning the screw holes on the drive with the screw holes on the bracket rails and then
inserting and tightening all four screws (two screws on each rail).
1 drive
2 bracket rails (2)
3 screws (4)
2. Gently slide the drive into place until you hear a click or feel the drive securely installed.
3. Attach the power and floppy-drive cables to the floppy drive.
4. Connect the other end of the floppy-drive cable to the connector labeled DSKT on the system board.