6. Locate the correct slot for the drive and gently insert the drive into the bay, sliding it forward until you hear a click or feel the drive securely installed.

1 drive

2 slot verification number

7. Replace the floppy drive and CD/DVD drive.

8. Check all connectors to be certain that they are properly cabled and firmly seated.

9. Close the computer cover.

NOTICE:

To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.

10. Connect your computer and devices to electrical outlets.

See the documentation that came with the drive for instructions on installing any software required for drive operation.

11. After you open and close the cover, the chassis intrusion detector, if installed and enabled, causes the following message to appear on the screen at

the next computer start-up:

ALERT! Cover was previously removed.

12.

Reset the chassis intrusion detector

NOTE:

If an admin password has been assigned by someone else, contact your network administrator for information on resetting the chassis intrusion

detector.

13. If the drive you just installed is the primary drive, insert a bootable medium into your boot drive.

14. Turn on the computer.

by changing Chassis Intrusion to On or On-Silent.

Table of Contents