Dell GX280DT - GX280 Desktop Computer User Manual page 237

5. If you are removing the card permanently, install a filler bracket in the empty card-slot opening.
If you need a filler bracket, contact
NOTE: Installing filler brackets over empty card-slot openings is necessary to maintain FCC certification of the computer. The brackets also keep dust
and dirt out of your computer.
6. Lower the retention arm and press it into place.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
7. Close the computer cover, reconnect the computer and devices to electrical outlets, and turn them on.
After you open and close the cover, the chassis intrusion detector, if installed and enabled, causes the following message to appear on the screen at
the next computer start-up:
ALERT! Cover was previously removed.
8. Reset the chassis intrusion detector
NOTE: If an admin password has been assigned by someone else, contact your network administrator for information on resetting the chassis intrusion
detector.
Serial Port Adapters
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
NOTE: The serial port adapter for your small mini-tower computer also includes two PS/2 connectors.
Installing a Serial Port Adapter
1. Follow the procedures in "Before You
2. Raise the retention arm.
3. Remove the filler bracket.
4. Slide the serial port adapter bracket down over the card-slot opening, and lower the retention arm, ensuring that:
The tops of all cards and filler brackets are flush with the alignment bar.
l
The notch in the top of the adapter or filler bracket fits around the alignment guide.
l
5. Press the retention arm into place, securing the adapter in the computer.
Dell.
by changing Chassis Intrusion to On or On-Silent.
Begin."