Removing A Pci Express X16 Card - Dell GX280DT - GX280 Desktop Computer User Manual

User guide
Hide thumbs Also See for GX280DT - GX280 Desktop Computer:
Table of Contents

Advertisement

1 fully seated card
2 not fully seated card
3 bracket within slot
4 bracket caught outside of slot
 
6. Release the card lever, ensuring that the tab fits into the notch on the front end of the card.
 
7. Secure the card by lowering the lever on the back panel.
 
8. Replace the computer cover.
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
 
9. Connect your computer and devices to electrical outlets, and turn them on.
After you open and close the cover, the chassis intrusion detector, if installed and enabled, causes the following message to appear on the screen at
the next computer start-up:
ALERT! Cover was previously removed.
 
10.
Reset the chassis intrusion detector
NOTE:
If an admin password has been assigned by someone else, contact your network administrator for information on resetting the chassis intrusion
detector.
 
11. If you installed a sound card:
a.
 Enter system
setup, select Audio Controller, and change the setting to Off.
b.  Connect external audio devices to the sound card's connectors. Do not connect external audio devices to the microphone, speaker/headphone,
or line-in connectors on the back panel.
 
12. If you installed an add-in network adapter and want to turn off the integrated network adapter:
a.
 Enter system
setup, select Network Controller and change the setting to Off.
b.  Connect the network cable to the add-in network adapter's connectors. Do not connect the network cable to the integrated connector on the
back panel.
 
13. Install any drivers required for the card as described in the card documentation.
 

Removing a PCI Express x16 Card

 
1. Follow the procedures in
"Before You
 
2. If necessary, disconnect any cables connected to the card.
 
3. Remove the card as instructed in
 
4. If you are removing the card permanently, install a filler bracket in the empty card-slot opening.
If you need a filler bracket,
contact
by changing Chassis Intrusion to On or On-Silent.
Begin."
step 2
in the preceding section.
Dell.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gx280 - optiplex - sd

Table of Contents