Installing a Floppy Drive
If you are replacing a drive and the the new drive does not have the bracket rails
1
attached, remove the rails from the old drive by removing the two screws that secure
each rail to the drive. Attach the bracket to the new drive by aligning the screw holes
on the drive with the screw holes on the bracket rails and then inserting and tightening
all four screws (two screws on each rail).
Gently slide the drive into place until the tabs securely click into position.
2
1
drive
2
bracket rails (2)
3
screws (4)
1
2
3
89
Drives