Error Messages - Dell GX280DT - GX280 Desktop Computer User Manual

User guide
Hide thumbs Also See for GX280DT - GX280 Desktop Computer:
Table of Contents

Advertisement

4-2-2
Shutdown failure
4-2-3
Gate A20 failure
4-2-4
Unexpected interrupt in protected mode
4-3-1
Memory failure above address 0FFFFh
4-3-3
Timer-chip counter 2 failure
4-3-4
Time-of-day clock stopped
4-4-1
Serial or parallel port test failure
4-4-2
Failure to decompress code to shadowed memory
4-4-3
Math-coprocessor test failure
4-4-4
Cache test failure
 Error Messages
Fill out the
Diagnostics Checklist
as you complete these checks.
 
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
If the message is not listed, see the documentation for the operating system or the program that was running when the message appeared.
 
A filename cannot contain any of the following characters: \ / : * ? " < > |  —
 
A required .DLL file was not found  —
1.  Click the Start button, click Control Panel, and then click Add or Remove Programs.
2.  Select the program you want to remove.
3.  Click the Change or Remove Program icon.
4.  See the program documentation for installation instructions.
 
Alert! Previous attempts at booting this system have failed at checkpoint [nnnn]. For help in resolving this problem, please note this checkpoint and
contact Dell Technical Support  —
 
Attachment failed to respond  —
 
Bad command or file name  —
 Ensure that you spelled the command correctly, put spaces in the proper place, and used the correct pathname.
 
Bad error-correction code (ECC) on disk read  —
 
Controller has failed  —
 See
"Drive
 
Data error  —
 See
"Drive
Problems."
 
Decreasing available memory  —
 See
"Lockups and Software
Problems."
 
Diskette drive 0 seek failure  —
 
Diskette read failure  —
 See
"Drive
Problems."
 
Diskette subsystem reset failed  —
 
Diskette write protected  —
 Slide the write-protect notch to the open position.
 
 The program that you are trying to open is missing an essential file. To remove and then reinstall the program:
  Contact Dell
and report the checkpoint code (nnnn) to the support technician.
 See
"Drive
Problems."
 See
"Drive
Problems."
Problems."
 See
"Drive
Problems."
 Run the
Dell
Diagnostics.
  Do not use these characters in filenames.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gx280 - optiplex - sd

Table of Contents