7. Check all cable connections, and fold cables out of the way to provide airflow for the fan and cooling vents.
8. Close the computer cover.
NOTICE:
To connect a network cable, first plug the cable in to the network wall jack and then plug it in to the computer.
9. Connect your computer and devices to their electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.
10. After you open and close the cover, the chassis intrusion detector, if installed and enabled, causes the following message to appear on the screen at
the next computer start-up:
ALERT! Cover was previously removed.
11.
Reset the chassis intrusion detector
NOTE:
If an admin password has been assigned by someone else, contact your network administrator for information on resetting the chassis intrusion
detector.
12. Update your configuration information by setting the appropriate Drive option (0 or 1) under Drives. See
13. Verify that your computer works correctly by running the