Dell GX280DT - GX280 Desktop Computer User Manual page 211

Floppy Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.
1. Follow the procedures in "Before You
2. If you are installing a new floppy drive rather than replacing a drive,
Removing a Floppy Drive
1. Disconnect the floppy-drive cable from the
2. Remove the power cable from the interposer board.
3. Remove or raise the drive by pressing the green tabs on either side of the drive and lifting the drive up.
4. Remove the floppy-drive cable from the floppy drive:
a. Remove the interposer board from the floppy drive by pressing on the tab and rotating the interposer board.
b. To release the floppy-drive cable from the connector, slide the lever until it is fully extended, and then lift the cable away.
1 tab
2 interposer board
3 lever
4 floppy-drive cable
5 system board floppy-drive connector (DSKT)
Begin."
remove the front-panel
system board connector (DSKT).
inserts.