1. If you are replacing a drive and the new drive does not have the bracket rails attached, remove the rails from the old drive by removing the two screws

that secure each rail to the drive. Attach the bracket to the new drive by aligning the screw holes on the drive with the screw holes on the bracket rails

and then inserting and tightening all four screws (two screws on each rail).

1 drive

2 bracket rails (2)

3 screws (4)

2. Gently slide the drive into place until you hear a click or feel the drive securely installed.

3. Attach the power and floppy-drive cables to the floppy drive.

4. Connect the other end of the floppy-drive cable to the connector labeled "DSKT" on the

1 power cable

2 floppy-drive cable

3 floppy-drive connector (DSKT)

system

board.