Dell GX280DT - GX280 Desktop Computer User Manual page 52

2. If you are replacing an existing drive:
a. Use a small flat-edge screw driver on the backside of the panel insert to gently pop off the insert.
b. Remove the shoulder screws (4) from the old drive.
3. Insert the shoulder screws (4) into the sides of the new floppy drive and tighten.
1 drive
2 shoulder screws (4)
4. Attach the power and floppy-drive cables to the floppy drive.
5. Gently slide the drive into place until you hear a click or feel the drive securely installed.
1 power cable
2 slot verification number
6. Replace the CD/DVD drive
7. Check all cable connections, and fold cables out of the way to provide airflow for the fan and cooling vents.
8. Close the computer cover.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
9. Connect your computer and devices to their electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.
10. After you open and close the cover, the chassis intrusion detector, if installed and enabled, causes the following message to appear on the screen at
the next computer start-up:
ALERT! Cover was previously removed.
11. Reset the chassis intrusion detector
NOTE: If an admin password has been assigned by someone else, contact your network administrator for information on resetting the chassis intrusion
detector.
12. Enter system setup and use the Diskette Drive option to enable your new floppy drive.
by changing Chassis Intrusion to On or On-Silent.