Tools Required - HP StorageWorks 2/64 - Core Switch Reference Manual

Tools Required

12
Table 1. Contents of the Shipping Carton(s)
B Rear mounting brackets
C Rail assemblies
Other items not shown:
• hp StorageWorks Core Switch 2/64 Documentation CD
• hp StorageWorks Fabric Manager CD
• Two power cord retainers
• One 10 foot RS-232 serial cable, convertible to an RJ-45 cable
by removing the adapter on the end of the cable
• Two jumper cables that allow switch to PDU connections
• Cable guides
• Hardware used to install the switch in a rack
HP recommends the use of two separate power distribution units
Note
(PDUs) with the switch. Each PDU must have at least one C19 connector.
Purchase the PDUs separately. For more information, see
Specifications" on page
The following tools are required to install the switch in a rack:
• #2 Phillips and T25 Torx screwdrivers.
• 1/2-inch socket wrench to remove the pallet bolts.
• A lift capable of lifting a minimum of 250 pounds.
– Recommended Lift: LIFT-O-FLEX® 17000 SP 400 from R on I. For
more information, visit their Web site at
71.
getting started and general reference guide
"Power
.
http://www.roni.com/