Turning the Switch On and Off
OPERATING THE SWITCH
To provide power to the switch for the first time, refer to
Power to the Switch"
To turn on the switch:
• Verify both power cords are connected to the AC power connectors on
the port side of the chassis, and flip both green AC power switches to
"1". The green AC power switches illuminate when on.
To turn off the switch:
• Flip both AC power switches to "O". To remove all sources of power
from the switch, disconnect both cables from the power source.
Removing all power from the switch triggers a system reset. When
Note
power is restored, all devices are returned to the initial state and the switch
runs POST, which is complete when LED activity stops.
To skip POST, use the fastboot command. For more information about
this command, refer to the hp StorageWorks fabric os reference. A fast boot
requires approximately two minutes to complete.
on
page
31.
4
"Providing Initial
45