Brackets And Rails; Required Tools; Mounting The Adjustable Brackets In The Rack; Brackets Included In Kit - HP StorageWorks Edge Switch 2/12 Installation Manual

• Ten Phillips panhead screws (10-32 x 5/8) with flat washer (only 2 used)
• Six Phillips flathead screws (6-32 x 3/8) (not used)
• Twelve Phillips panhead screws (10-32 x 3/8) (not used)
• Four 8-32 Keps nuts (not used)

Brackets and rails

Figure 6 shows the brackets and rails included in the rack mount kit.
Two fixed-length slide rails (one left
1
and one right)
wo front brackets
2 T
Two rear brackets (long)
3
Figure 6

Brackets included in kit

Required tools

The following tools are required, but are not included in the kit:
• Torque driver with a T10 Torx bit
• #2 Phillips screwdriver

Mounting the adjustable brackets in the rack

Tools and equipment required:
• One #2 Phillips screwdriver
24 Installing the Edge Switch
1
3
4
5
4
5
2
Two rear spacing brackets
Rear bracket (short)---not used in this
configuration