Cf_Dline Command; Cf_Pcstore Command; Cf_Pcmodefree Command - Sanyo PLC-XC56 - 3100 Manual

PLC-XC56 Expand Serial Command Functional Specifications
8.5.7

CF_DLINE Command

Command "CF_DLINE_%1"[CR]
"0100"~"nnnn" --- Directly select Display Line setting value
%1
"UP" -------------- Current Display Line setting value + 1
"DN" -------------- Current Display Line setting value – 1
Set Display Line value of PC signal
Projector does not save the value set with this command so that it returns its
Details
original when projector turning into Stanby mode or ALL is OFF.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.5.8

CF_PCSTORE Command

Command "CF_PCSTORE_%1"[CR]
"MODE1" ---- Store current PC Adjust status to Mode1
"MODE2" ---- Store current PC Adjust status to Mode2
%1 "MODE3" ---- Store current PC Adjust status to Mode3
"MODE4" ---- Store current PC Adjust status to Mode4
"MODE5" ---- Store current PC Adjust status to Mode5
Store current PC Adjust status (each parameter status such as Total dots) to
Mode1~Mode5. This command operates the same way as storing to
Details
Mode1-Mode5 in PC Adjust MENU.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.5.9

CF_PCMODEFREE Command

Command "CF_PCMODEFREE_%1"[CR]
"MODE1" ---- Set Mode1 to Free status
"MODE2" ---- Set Mode2 to Free status
%1 "MODE3" ---- Set Mode3 to Free status
"MODE4" ---- Set Mode4 to Free status
"MODE5" ---- Set Mode5 to Free status
Delete the registered data in Mode1-Mode5 and turns it to Free status.
This command operates the same as turning Mode1-Mode5 to Free in PC Adjust
Details
Menu.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
"nnnn" shows maximum value, it is current Total Line value – Vertical
Position value
"000"[CR]
"101"[CR] ---- When Input for Video is selected
"000"[CR]
"101"[CR] ---- When Input for Video is selected
"000"[CR]
"101"[CR] ---- When Input for Video is selected
21 / 65