Digi TS 8 MEI User Manual page 157

Using the Reset button
If the Digi device cannot be accessed from the web interface, the configuration can be restored to
factory defaults by using the Reset button.
Power off the Digi device.
1
Locate the Reset button or pin on your device.
2
Here is the reset button for a Digi Connect SP unit.
For Digi Connect EM or Digi Connect Wi-EM, the Reset button is located between P3
and CR1, as shown:
Digi Connect ME and Digi Connect Wi-ME do not have a reset button. Instead, pin 20
(the /init pin) is shorted to ground.
For Digi Connect ES, the reset switch is on the side panel.
3 Hold the Reset button down gently with a non-conductive, small diameter tool (such as
wood or plastic) with a blunt end (NOT SHARP or the button could be damaged). Power on
the device while holding the Reset button down.
D i g i d e v i c e a d m i n i s t r a t i o n
Reset button
Reset button
1 5 7