Digi TS 8 MEI User Manual page 125

Use the set wlan command to configure wireless network settings. This command is
8
described in the Digi Connect Family Command Reference, available for download from the
Digi Support site and also on the Software and Documentation CD for command
descriptions.
After configuring the Digi Connect Wi-SP parameters to function within your network,
9
disconnect the power supply and the serial cable from the Digi Connect Wi-SP.
Reset the DIP switch settings according to serial device requirements (EIA-232/422/485).
10
Switch Switch
Settings Settings
Pinouts Pinouts
Connect the antenna and the power supply to the Digi Connect Wi-SP.
11
Start the Digi Device Setup Wizard to discover and the configure the Digi Connect Wi-SP
12
for your network.
See also Digi support site at http://www.digi.com/support/ for additional command
Note
resources.
EIA-232 EIA-232
Up/On Up/On
Down/Off Down/Off
1 1 DCD DCD
2 2 RxD RxD
3 3 TxD TxD
DB-9 DB-9 4 4 DTR DTR
5 5 GND GND
6 6 DSR DSR
7 7 RTS RTS
8 8 CTS CTS
9 9 RI RI
Shell Shell GND GND
*If switch 4 is up, termination resistor connected *If switch 4 is up, termination resistor connected
If down, termination resistor not connected. If down, termination resistor not connected.
C o n f i g u r e D i g i d e v i c e s
EIA-422/485 EIA-422/485 EIA-485 EIA-485
Full-Duplex Full-Duplex Half-Duplex Half-Duplex
* *
* *
* * * * * *
CTS- CTS- Not Used Not Used
RxD+ RxD+ RxD+ RxD+
TxD+ TxD+ TxD+ TxD+
RTS- RTS- Not Used Not Used
GND GND GND GND
RxD- RxD- RxD- RxD-
RTS+ RTS+ Not Used Not Used
CTS+ CTS+ Not Used Not Used
TxD- TxD- TxD- TxD-
1 2 5