6: Configuration Via Telnet Or Serial Port (Setup Mode); Accessing Setup Mode; Telnet Connection - Lantronix UDS1100 User Manual

6: Configuration via Telnet or Serial Port (Setup
Mode)
You must configure the unit so it can communicate on a network with your serial device.
As an alternative to using a web browser, as described in the previous chapter, you can
use the following procedures remotely or locally:
Use a Telnet connection to configure the unit over the network.

Use a terminal or terminal emulation program to access the serial port locally.

The series of prompts at which you enter configuration settings is called Setup Mode.
Note: Detailed information about other setup methods is available from your
Lantronix Sales Associate.
The unit's configuration is stored in nonvolatile memory and is retained without power.
You can change the configuration at any time. The unit performs a reset after the
configuration has been changed and stored.
This chapter tells you how to access Setup Mode and the general procedure for using it.
To complete the configuration, continue with
8: Setup Mode: Channel
Note: The menus in the configuration chapters show a typical device. Your
device may have different configuration options.

Accessing Setup Mode

Telnet Connection

To configure the unit over the network, establish a Telnet connection to port 9999.
Note: You can also use DeviceInstaller to access Telnet. Select the device from
the main window list, and click the Telnet Configuration tab. Skip steps 1 and 2.
To establish a Telnet connection:
1. From the Windows Start menu, click Run and type the following command, where
x.x.x.x is the IP address, and 9999 is the unit's fixed network configuration port
number:
2. Click OK. The following information displays.
UDS1100 User Guide
7: Setup Mode: Server
Configuration, and 9: Setup Mode: Advanced
Windows: telnet x.x.x.x 9999
UNIX: telnet x.x.x.x:9999
Configuration,
Settings.
36