HP D5970A - NetServer - LCII Manual page 8

Chapter 1
Unpack Rack Enclosures and Hardware, and Remove the Shipping Panels, Doors, and
Side Panels (If applicable)
WARNING
Use care in moving the rack down from the pallet. Three
people are required for this step.
1. Follow pictorial instructions on the shipping container to unbox the rack
enclosure.
2. Adjust the leveler feet under each of the four corners of each rack. Lower
each leveler foot to be in firm contact with the floor.
CAUTION The leveler feet prevent the rack from rolling away from you
when you install components. Be sure they have been lowered
before you put anything into the rack.
3. Find and extend the anti-tip foot at the front of the rack before you mount
any rack equipment on slides.
WARNING
4. Remove any shipping panels from inside the rack enclosure. Save panels,
screws, and rack nuts if you are going to reship the rack.
4
When equipment is mounted on sliding rails, a tip-over
hazard exists. Always take the precautions listed below:
Extend or bolt on the anti-tip foot for each rack before
mounting equipment on slides.
Never extend more than one piece of equipment on slides at
a time.
Reduce weight by removing power supplies and hard disk
modules from servers.
Always use the rack mounting handles that are shipped on
rack optimized units as shown in the accompanying
instructions.
About This Cabling Reference