230/240V Pdu Rack Power Configurations - HP D5970A - NetServer - LCII Manual

Chapter 2

230/240V PDU Rack Power Configurations

Configurations for the 230/240 VAC, PDU options are shown in the text below,
Table 5 and Figure
2-
230/240 VAC Power Configuration
In a country with a 230/240 VAC power system, the high-voltage (230/240 V)
PDU model E7671A is required. If you are using a UPS, attach the C19 end of
the accompanying power cord to the PDU and attach the C20 end of the same
cord to the IEC 320 receptacle in the rear of the UPS.
Alternate 230/240 VAC Power Configuration
When the 230/240 VAC PDU is in use without a UPS in the rack, the PDU is
shipped with a localized power cord. For example, Figure
standard cord. For use with 230/240 VAC power mains, direct connection to a
junction box is usually necessary. In this case, an unterminated power cord is
supplied. Be sure to obey all local electrical code requirements when connecting
to the site electrical power supply.
Connecting and Routing Cables to the HP NetServer LPr
13.
2-
13 shows the EC
2-
39