Download  Print this page

Pci Retention Clamp - HP Xw8400 - Workstation - 4 GB RAM User Manual

Hp xw8400 service and technical reference guide.
Hide thumbs

Advertisement

2.
For short or tall PCI cards, attach the hooks of the PCI retainer (1) under the slots on the rear of
the chassis, and then rotate the retainer down until the retainer arm (2) supports the card.
Figure 4-19

PCI retention clamp

1.
Disconnect power from the system (
access panel
facing up.
2.
Open the PCI retention clamp by pressing down on the two green clips at the ends of the clamp
and rotating the clamp toward the back of the system.
Figure 4-20
ENWW
Installing the short or tall card PCI retainer
(Access panel on page
Opening the PCI retention clamp
Pre-disassembly procedures on page
60). Place the workstation on its side with the system board
Removing and replacing components
55), and remove the
73

Advertisement

Table of Contents

   Related Manuals for HP Xw8400 - Workstation - 4 GB RAM

Comments to this Manuals

Symbols: 0
Latest comments: