Figure 5-2 Receiver Control Panel - HP Xw460c - ProLiant - Blade Workstation User Manual

After the Receiver starts, you'll see the Receiver Control Panel (see Figure 5-2).
Figure 5-2 Receiver Control Panel
To create an RGS connection, enter the hostname or IP address of the Remote Computer in the Hostname dialog
box, and press Enter or click Connect.
NOTE: At RGS 5.2.5, the capability was added to specify the port number used by the RGS Sender. The default
Sender port number is 42966. The Sender port number can be changed using the Rgsender.Network.Port
property. If this property is used to change the Sender port number from its default value of 42966, the Sender port
number must then be specified in the above Hostname dialog box, in either of the following formats:
hostname:port number
IP address:port number
For example, if the Rgsender.Network.Port property is used to change the Sender port to 42970, the Sender
IP address in Figure 5-2 would need to be modified to include the port number, as follows:
15.2.76.29:42970
Provide a username and password, as prompted. If the connection succeeds, the Remote Display Window will be
displayed on the Local Computer, showing the desktop session of the Remote Computer (see Figure 5-3).
Figure 5-3 Remote Display Window
Remote
Remote Display Window
Display
Window
Local Computer Desktop
Local Computer Desktop
Using RGS 81