Sender General Properties - HP Xw460c - ProLiant - Blade Workstation User Manual

USB access control list properties group
•
•
Rgsender.Usb.Acl.RulesetPath
•
Rgsender.Usb.Acl.SchemaPath
•
Rgsender.Usb.Acl.RulesetErrorTimeout
NIC binding properties group
•
•
Rgsender.Network.IsListenOnAllInterfacesEnabled
•
Rgsender.Network.Interface.n.IsEnabled
•
Rgsender.Network.AllowIpAddressSubnet
•
Rgsender.Network.Port
Clipboard property group
•
•
Rgsender.Clipboard.IsEnabled

8-6-2 Sender general properties

Rgsender.IsRdpLogoutDetectionEnabled=bool
This property only applies to the Windows versions of the RGS Sender.
When a user disconnects from a Remote Desktop Protocol (RDP) session, the Windows desktop on the Remote
Computer is immediately available for an RGS connection. However, if the user logs out of the RDP session, the
RGS Sender will be unable to access the desktop for about 60 seconds. If this property is set to 1, the desktop will
be available to RGS almost immediately. The RGS Sender will monitor the RDP session for a logout, and begin the
process of making the desktop available as soon as the logout is detected. If set to 0, the RGS Sender will not
monitor the RDP session for a logout. The default is 1—allow quick access to the Windows desktop after Remote
Desktop logout.
Rgsender.IsCopyRegionEnabled=bool
If set to 1, RGS Copy Regions are sent from the Sender to the Receiver. If set to 0, RGS Copy Regions are turned
off and will be sent to the Receiver as Image Update Regions. This is for advanced use and should not be set. The
default value is 1—send RGS Copy Regions.
Rgsender.IsRegionLimitEnabled=bool
This property is used to limit the number of update rectangles in a update region. This is for advanced use and
should not be set. The default value is 0—don't limit regions.
Rgsender.IsDisconnectOnLogoutEnabled=bool
If set to 1, the RGS connection will be disconnected when the user logs out. If set to 0, the RGS connection will
remain connected to the Sender when the user logs out. The default value is 1—always disconnect when the user
logs out.
Rgsender.IsSnapToCodecEnabled=bool
If set to 1, the HP Codec will be aligned or snapped to tile boundaries. This will avoid persistent visual artifacts at
the expense of potentially increased bandwidth usage. If set to 0, the alignment of the codec with respect to the
screen will be arbitrary, as determined by the exposed or modified region. For user desktops that contain
primarily 2D applications, turning off this property can save network bandwidth. The default value is 1—always
snap the codec to tile boundaries.
(1)
(1)
(0)
(1)
(1)
RGS properties 158