Receiver Audio Properties; Receiver Microphone Property; Receiver Usb Properties - HP Xw460c - ProLiant - Blade Workstation User Manual

8-5-5 Receiver audio properties

Rgreceiver.Audio.IsMutable=bool
If set to 1, the user will be able to modify all audio controls in the RGS Receiver. If set to 0, none of the audio
controls can be modified by the user. The default value is 1—the audio controls can be modified by the user.
Rgreceiver.Audio.IsEnabled=bool
Rgreceiver.Audio.IsEnabled.IsMutable=bool
If set to 1, the RGS audio subsystem will be enabled. If set to 0, RGS audio will be disabled and no network
bandwidth will be consumed for remote audio. The default value is 1—audio is enabled.
Rgreceiver.Audio.Quality=int
Rgreceiver.Audio.Quality.IsMutable=bool
The audio quality property can be set to low (0), medium (1), or high (2) quality. This property is used to adjust
the sample rate of the streaming audio. Less information is sent over the network if the sample rate is lower—and,
therefore, the less network bandwidth that is consumed. The default value is 1—medium audio quality.
Rgreceiver.Audio.IsFollowsFocusEnabled=bool
Rgreceiver.Audio.IsFollowsFocusEnabled.IsMutable=bool
If set to 1, enables only the audio stream associated with the Remote Display Window that currently has the -
keyboard focus. The audio stream from all other active connections is disabled. Setting the property to 0 combines
the audio from all active connections into a single stream. The default value is 0—combine audio from all active
connections, and play in a single stream.
Rgreceiver.Audio.IsInStereo=bool
Rgreceiver.Audio.IsInStereo.IsMutable=bool
If set to 1, stereo is enabled, and both the left and right channels are transmitted. The highest quality audio (2)
with stereo enabled is equivalent to CD quality audio but consumes more network bandwidth. The default value is
1—stereo is enabled.

8-5-6 Receiver microphone property

Rgreceiver.Mic.IsEnabled=bool
Rgreceiver.Mic.IsEnabled.IsMutable=bool
This property is new with the RGS 5.1.3 release. If set to 1, remote microphone is enabled (on/unmuted). The
default value is 0—remote microphone is disabled (off/muted).

8-5-7 Receiver USB properties

Rgreceiver.Usb.IsMutable=bool
If set to 1, the user can modify all USB controls in the Receiver Control Panel. If set to 0, none of the USB controls
can be changed by the user. This property can be used to permanently enable or disable remote USB before the
RGS Receiver is started. The default value is 1—the user can modify all USB controls.
Rgreceiver.Usb.IsEnabled=bool
Rgreceiver.Usb.IsEnabled.IsMutable=bool
If set to 1, remote USB will be enabled. If set to 0, remote USB will be disabled. The default value is 1—remote
USB is enabled.
(1)
(1)
(1)
(1)
(1)
(0)
(1)
(1)
(0)
(1)
(1)
(1)
(1)
(1)
RGS properties 151