Sender Logging; Figure 6-33 Logsetup File - HP Xw460c - ProLiant - Blade Workstation User Manual

6-7-2 Sender logging

RGS Sender logging is not controlled by a GUI—instead, Sender logging is controlled by a particular file on the
RGS Sender. In Section 3-1-2,
Rgsender.exe is described:
-l logSetupFile—Specifies the "logSetupFile" file used to describe various logging parameters for
Sender error and informational output. This file is used to determine where the output goes (to a file or to
standard error) as well as the type of output logged (INFO or DEBUG). At installation, the Sender default is
with "-l logSetup" turned on, where the logSetup file in the installation directory is set for output to a
file named rg.log at INFO debug level.
Unless this command line option is used to change the logSetupFile file, the default logSetup file in the
Sender installation folder (C:\Program Files\Hewlett-Packard\Remote Graphics Sender) is used.
The first few lines of logSetup are shown in Figure 6-33.
Figure 6-33 logSetup file
The highlighted, uncommented line specifies that INFO-level logging is used, and that logging will occur only to
the rg.log file (no STDOUT logging). If another logging level is required, edit the file to replace INFO with any
of the following: DEBUG, WARN, ERROR, or FATAL. If STDOUT logging is required, or if both STDOUT and
rg.log logging are required, uncomment out the appropriate line (and comment out the previously-uncommented
line).
NOTE: The logSetup file is set to read-only during Sender installation, so you'll need to uncheck the Read-
only property to edit the file.
NOTE: In order to log Remote Clipboard activities on the Sender, DEBUG-level logging (not the default INFO-
level logging) must be specified in the logSetup file.
"Installing the Sender on Windows," the following command line option for
Advanced capabilities 134