Changing The Setup Mode Hotkey Sequence - HP Xw460c - ProLiant - Blade Workstation User Manual

Setup Mode Hotkey: The text dialog and the Set and Reset buttons allow you to redefine the Setup Mode
•
hotkey sequence from its default value. As shown in the Receiver Control Panel of Figure 6-23, the default
hotkey sequence to activate Setup Mode is:
Press and hold down the Shift key.
At the same time, press then release the space bar—this activates Setup Mode. You will remain in Setup Mode until you
release the Shift key.
Additional hotkeys—The following hotkeys are also supported; these hotkeys can be entered as either upper
•
case or lower case:
"H"—Toggles the Remote Display Window Toolbar on and off (see Section 5-1-3,
Window
"M"—Restores the Receiver Control Panel if it has been minimized (iconified). Also brings the Receiver
Control Panel to the front if it is obscured by other windows.
"N"—Minimizes (iconifies) the Remote Display Window
"C"—Closes the Remote Display Window, which terminates the RGS connection
If Setup Mode is activated by the hotkey sequence (as opposed to the Setup Mode button), and you have multiple
Remote Display Windows on your computer, you can bring up the Remote Display Window selection dialog to
view a thumbnail image of each Remote Display Window (see
Directory Mode).

6-5-1 Changing the Setup Mode hotkey sequence

RGS allows you to change the Setup Mode hotkey sequence from its default value of:
Shift Down, Space Down, Space Up
In defining a new Setup Mode hotkey sequence, the following keys can be used:
LCtrl, RCtrl, Ctrl— Specifies a left, right or side-insensitive Ctrl key, respectively.
•
LAlt, RAlt, Alt— Specifies a left, right or side-insensitive Alt key, respectively.
•
•
Shift
•
Space
Every sequence must begin with Ctrl, Alt, or Shift. Two actions are associated with each key:
Down: Specifies a key press.
•
Up: Specifies a key release.
•
To change the hotkey sequence, first press the Set button under the Hotkeys tab. Then press and release the keys
that you want to form the Setup Mode hotkey sequence. The first key that you enter must be held down until you
are done entering the other key(s). This is identical to the process of actually activating Setup Mode, where the
first key is likewise held down while the other key(s) are pressed and released, followed by releasing of the first
key.
As you press and release the keys, the key sequence is displayed in the dialog box.
To define a sequence that is side-insensitive, you'll need to modify the property value from outside of the GUI
while RGS is not running. See Section 8-5-9,
sequence from outside of the GUI.
Pressing the Reset button on the Receiver Control Panel restores the Setup Mode hotkey sequence to its original
default values.
Toolbar")
"Receiver hotkey
Selecting Remote Display Windows while in
properties," for information on modifying the
Advanced capabilities 125
"Remote Display