Starting The Receiver In Directory Mode; Figure 7-1 Starting The Receiver In Directory Mode; Figure 7-2 The Receiver Control Panel In Directory Mode - HP Xw460c - ProLiant - Blade Workstation User Manual

7-1-2 Starting the Receiver in Directory Mode

Before attempting a connection in Directory Mode for the first time, HP recommends that you verify that RGS can
connect to each computer individually in Normal Mode (see Section 5-1,
noted in Section 5-1, the pre-connection checklist (see Chapter 4,
that the computer and network parameters are set correctly. After Normal Mode connectivity is verified, start the
Receiver in Directory Mode (see Figure 7-1).
Figure 7-1 Starting the Receiver in Directory Mode
Alternatively, the Receiver can be started in Directory Mode from a command line, using either of the following:
C:\Program Files\Hewlett-Packard\Remote Graphics Receiver\rgreceiver.exe -directory "file"
C:\Program Files\Hewlett-Packard\Remote Graphics Receiver\rgreceiver.exe -directory
If a file name is specified after -directory, the Receiver will use that file as the directory file. If no file name is
specified, the user is prompted by RGS to specify the path and name of the directory file.
In Directory Mode, the Receiver Control Panel displays the name of the directory file (see Figure 7-2). The Change
button enables you to specify a different directory file. The Connect All button is used to establish a connection to
the Remote Computers listed in the directory file.
Figure 7-2 The Receiver Control Panel in Directory Mode
After clicking Connect All, you'll need to independently authenticate and log into each Remote Computer.
"Using RGS in Normal
"Pre-connection checklist") can be used to verify
Using Directory Mode 137
Mode"). As