Figure 4-35; Figure 4-36 - HP Visualize b1000 - Workstation Handbook

Field Replaceable Units
FRU Removal and Replacement
Figure 4-35. Removing the Floppy Disk's Rear Cover
3. Rotate the system unit around until you see the front of the workstation as shown in

Figure 4-36.

Figure 4-36. Front of Workstation with the Front Panel Removed
4. Remove both floppy disk bracket screws (T-15 Torx screws) and pull the floppy disk
bracket out of the chassis assembly as shown in Figure 4-37. Next remove the four
floppy disk blank screws (T-10 Torx screws) as shown in Figure 4-37. and remove the
blank from the bracket. You are now ready to mount the floppy disk drive into the
floppy disk bracket.
126
Power Cable
Floppy Data Cable
LCD
Power Switch
Rear Cover
Rear Cover
Handle
T-15
Torx/slotted
Screw
CD Drive
Blank
Floppy Drive
Bank
Chapter 4