Hard Disk Drive - HP Visualize b1000 - Workstation Handbook

Field Replaceable Units
FRU Removal and Replacement

Hard Disk Drive

This section describes installation and removal of hard disk drives in the B1000/C3000
workstation.The first subsection details how to install a hard drive, the second subsection
details how to remove a hard disk drive and the final subsection describes how to configure
the hard disk after it is installed.
The B1000/C3000 workstations may have a maximum of two hard drives. The hard drive
that came with the workstation was set to SCSI ID 6. If adding a second hard disk drive,
the second hard disk drive will use SCSI ID 5. Note that the two slots for the hard disk
drives have SCSI ID numbers 5 and 6 preassigned to them. You will not be able to change
the SCSI ID numbers.
NOTE Do not use SCSI ID 7 for any of the internal or external disk drives. The host
SCSI controller uses SCSI ID 7.
Installing a Hard Disk Drive
NOTE If you are installing a new hard disk drive, the slotted pan screws for
attaching the drive in the carrier are stored on the carrier rails. Also, see the
section titled "Hard Disk Drive Configuration" in Chapter 2 in this manual.
1. Open the front panel of the workstation, refer to the section "Opening the System Unit
Front Panel." In the front lower-right corner of the workstation, there are two hard
drive slots. The slot on the far right is the one discussed in this section. See Figure 4-48.
134 Chapter 4