HP Visualize b1000 - Workstation Handbook page 76

Troubleshooting
Selftest Failures
Table 3-2. Chassis Codes for B1000/C3000 Workstations
Ostat Code FRU
WRN 9C6s EXT IO
INI 9C8t EXT IO
WRN 9C8t EXT IO
INI 9CDB IO BD
WRN 9CDB IO BD
FLT A088 IO BD
WRN A008 EXT IO
WRN A0BD EXT IO
FLT A0FF EXT IO
WRN A50F EXT IO
WRN A70F EXT IO
INI C10m SYS BD
INI C30m SYS BD
INI C30C SYS BD
INI C3FF SYS/IO
FLT C3FF SYS/IO
INI C4CC SYS BD
INI C4CD SYS BD
INI C4CE SYS BD
INI C4CF SYS BD
INI C500 SYS BD
76
Message
bad PCI slot s
cnfg mon type t
mon type t fail
consl is SER_LDB
bad init SER_LDB
consl path fault
no boot device
device not ready
unknown launch
init pri pth err
init otr pth err
CPUm is monarch
monarchm test
mnrch slv chck
late monarch tst
late monarch flt
initialize ccp
no ccp found
ccp disabled
ccp found
get primary path
Description
Graphics in PCI slot s failed to initialize
as a console device.
Set graphics console to monitor type t.
(Seen when cycling through types.)
Failed to configure console to monitor type
t.
Console display is on serial LDB port.
Serial LDB port failed to initialize as a
console device.
Unable to boot--no console device found.
Unable to boot--no bootable device found.
Boot device not ready--operation may be
retried.
Unable to boot. Explanation may appear
on console.
Unable to boot from primary boot device.
Unable to boot from non-primary boot
device.
CPU m was chosen as the monarch
processor. (All other CPUs are slaves.)
CPU m finished the monarch-only tests
and system initialization.
The monarch CPU is checking whether
the slaves are in the correct rendezvous.
The monarch CPU is starting the late
(post-memory) monarch-only tests.
The late (post-memory) monarch-only
tests failed.
Searching for (lab-only) debugger card.
Debugger card not found.
Debugger card disabled.
Debugger card found.
Autoboot is reading primary boot path
from stable store.
Chapter 3