Memory Failures - HP Visualize b1000 - Workstation Handbook

Table 3-2. Chassis Codes for B1000/C3000 Workstations
Ostat Code FRU
INI CC4n SYS BD
TST D000 SYS BD
WRN D004 SYS BD
INI D005 SYS BD
INI D006 SYS BD
WRN D007 SYS BD
FLT D01n SYS/IO
WRN D02n SYS/IO

Memory Failures

The B1000/C3000 system requires Memory Page Deallocation to be implemented. This
feature allows the workstation to provide information to the operating system about
memory failures.
HP-UX 10.20 or later uses information to map out failing memory areas and continue
normal operation. You can use the command memrpt with the detail switch to obtain
information about the Memory Page Deallocation Table (PDT) as well as single-bit errors
logged by the system.
# /usr/sbin/sysdiag
DUI > logtool
LOGTOOL> memrpt detail
The PDT can also be checked using the pdt command in the Service menu of the Boot
Console Handler (refer to "Boot Console Menus" on page 159).
For allowable memory configurations see Chapter 2 of this manual.
Chapter 3
Message
CPU n mem rendez
micro controller
micro not resp
set dom1 fan spd
set dom2 fan spd
bad microctl cmd
fan n: failure!
fan n: too slow!
Enter
Enter
Enter
Description
Slave CPU n entering memory
rendezvous, waiting for the monarch CPU
to select a boot device.
Firmware is initializing communications
with the system controller.
Firmware detected a communications
error with the system controller.
Firmware is initializing communications
with the system controller.
Firmware is initializing communications
with the system controller.
Firmware detected a communications
error with the system controller.
Firmware detected system fan n stopped.
Firmware detected system fan n is
running too slowly.
Troubleshooting
Selftest Failures
83