Figure 5-35 Tightening The Bracket Screws; Figure 5-36 Replacing The Rear Floppy Disk Drive Bay's Cover - HP Visualize b1000 - Workstation Owner's Manual

Changing Your Computer Hardware Configuration
Removable Media Devices
7. Tighten the two floppy disk bracket screws as shown in Figure 5-35.
Figure 5-35 Tightening the Bracket Screws
8. Make sure that the floppy data and power cables are positioned so
Figure 5-36 Replacing the Rear Floppy Disk Drive Bay's Cover
138
You will need to tighten them using 6 inch-pounds of torque.
Bracket Screw
that they come out of the top edge of the rear floppy disk drive bay's
cover. This edge is rounded to prevent cutting of the cables. See
Figure 5-36. Put the rear cover in place and tighten the T-15
Torx/slotted screw using 6 inch-pounds of torque.
Rear Cover Handle
Power
Cable
Rear Cover
Data Cable
Bracket Screw
T-15
Torx/slotted
Screw
Chapter 5