Removing Memory; Figure 5-47 Propping Up The Power Supply - HP Visualize b1000 - Workstation Owner's Manual

NOTE
Figure 5-47

Removing Memory

Perform the following steps to remove memory (DIMM cards) from your
system unit.
Lay the system on its right side (using the system unit's front panel as a
reference) as shown in Figure 5-47. Note that before laying the system
unit on its side you should put it on a cushioned surface to avoid damage
to the system unit's exterior.
1. Open the side panel of the system unit as explained in the section
"Opening the Left Side Panel of the System Unit" in this chapter.
2. Prop up the system unit power supply as explained in the section
"Propping Up the System Unit Power Supply" in this chapter.
Propping Up the Power Supply
Hard Disk
Drive Fan
3. Remove the fan from the hard disk drive chassis. See the section
"Removing the Fan from the Hard Disk Drive Area" in this chapter.
Chapter 5
Changing Your Computer Hardware Configuration
DIMM connector
Memory Cards
Power
Supply
Hard Disk
Drive Fan
Bracket
157