Displaying The Status Of The System I/O - HP Visualize b1000 - Workstation Owner's Manual

Displaying the Status of the System I/O

The io command lets you identify all built-in I/O devices and optional
I/O devices installed in the option slots. It is available in the Information
Menu.
To use the IO command from the Information Menu of the boot console,
type the following command at the prompt and press
Information Menu: Enter command> io
Information about the built-in and optional I/O devices is displayed.
I/O MODULE INFORMATION
Path Decimal
---- -------
LAN 10/0/12/0
AUDIO 10/0/13/0
IDE 10/0/14/0
SUPERIO MISC 10/0/14/0
FLOPPY 10/0/14/1/0 Floppy Disk
SERIAL_1 10/0/14/1/1 RS232 port
SERIAL_2 10/0/14/1/2 RS232 port
PARALLEL 10/0/14/1/3 Parallel port built-in
USB 10/0/14/2
SCSI 10/0/15/0
FWSCSI 10/0/15/1
GRAPHICS(2) 10/6/2/0
Main Menu: Enter command >
Chapter 6
Displaying the Status of the System I/O
Type Location
---- --------
Ethernet built-in
Audio built-in
IDE built-in
Bridge Device built-in
built-in
built-in
built-in
USB built-in
SCSI built-in
SCSI built-in
Display slot 2
The Boot Console Interface
:
Enter
IODC IODC
HVER SVER Vers
---- ---- ----
0060 a200 0x02
0060 a300 0x00
0060 8c00 0x01
0060 8c00 0x01
0060 a900 0x95
0060 a300 0x00
0060 a300 0x00
0070 8500 0x01
Dep
---
0x00
0x00
0x00
0x00
0x00
0x00
0x00
0x00
193