Figure 5-26
CAUTION
4. Remove both floppy disk bracket screws (T-15 Torx/slotted screws)
and pull the floppy disk bracket out of the chassis assembly as shown
in Figure 5-26. Next remove the four floppy disk blank filler screws
(T-10 Torx/slotted screws) as shown in Figure 5-26 and remove the
blank from the bracket. You are now ready to mount the floppy disk
drive into the floppy disk bracket.
Removing the Floppy Disk Bracket and Blank
Blank Filler Screws
(T-10 Torx Screws)
Floppy disk drives are susceptible to mechanical and electronic shock.
When handling the drive, always wear the static-grounding wrist strap
that came in the floppy disk drive kit. Always handle the drive carefully.
Chapter 5
Changing Your Computer Hardware Configuration
Blank Screw
(T-15 Torx Screw)
Removable Media Devices
Bracket
Bracket
Screw
Blank
129