Replacing The Hard Disk Drive Fan - HP Visualize b1000 - Workstation Owner's Manual

Replacing the Hard Disk Drive Fan

To replace the bracket and fan, follow these steps:
1. Position the fan bracket so that the top alignment tabs will fit around
the two hard disk drive alignment screws, and the bottom alignment
tabs can slide down into their alignment holes as shown in Figure
5-10. Once the tabs are properly aligned, slide them into place.
2. Close the system unit as explained in the section "Propping Up the
Power Supply" in this chapter.
Chapter 5
Changing Your Computer Hardware Configuration
System Unit Fans
113